Volume 26, Issue 3 (Fall 2022)
jwss 2022, 26(3): 211-229 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Sadeghi M, Naeeni T, Kilanehei F, Galoie M. Numerical Investigation of Guide Walls Geometry at the Entrance of Dam Spillway (Case Study: Karun-3 Dam). jwss 2022; 26 (3) :211-229
URL: http://jstnar.iut.ac.ir/article-1-4189-en.html
URL: http://jstnar.iut.ac.ir/article-1-4189-en.html
Imam Khomeini International University, Qazvin , galavi@eng.ikiu.ac.ir
Abstract: (1695 Views)
One of the most important hydraulic structures in a dam is the spillway. The design of the ogee spillway crest is based on the lower profile of the free-flow jet passing through the sharp-crested weir. When the downstream ogee spillway profile for the design discharge conforms to the lower profile of the free-jet passing through the sharp-crested weir, the pressure on that surface of the spillway becomes zero. In this study, the design of the ogee spillway was performed initially based on both two- and three-dimensional numerical modeling and then compared to the USBR standard method. The comparison of the final numerical and analytical results showed that although the vertical two-dimensional outputs were completely in agreement with the USBR standard profile, the three-dimensional profiles were different because in this model, guide walls were not considered. According to the analysis, if the flow entering the spillway is parallel to its axis, the lower profile of the sharp-edge spillway will be in complete agreement with the standard profile. Since, the design of guide wall geometry for ogee spillways is carried out using physical modeling which iteratively revises during a high-cost trial and error procedure, this research based on the case study of the spillway of Karun-3 dam has been tried using numerical modeling. The closest geometry to the geometry of the overflow guide wall was obtained which creates the least difference in transverse velocities. In this way, the design of guide walls can be done with more accuracy and low cost in comparison to physical modeling.
Keywords: Ogee spillway, USBR standard profile, Sharp crested weir, Guide wall, Numerical simulation
Type of Study: Research |
Subject:
Ggeneral
Received: 2021/07/30 | Accepted: 2021/12/21 | Published: 2022/12/1
Received: 2021/07/30 | Accepted: 2021/12/21 | Published: 2022/12/1
| Rights and permissions | |
 | This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
